262 cam vs 272 cam

[alexklg]

I see. I've seen the megasquirt's discussion thread... but didn't pay much attention to it. Thanx for the info bro. Will check it out..

DIY? That's out of the question... haha... my electrical subject in UNI has been hopeless.. i don't think i can play with it myself... better ask some mech to install for me.. hehhee...

 

[prozac]

I was previously using Mitsu ECU on my Satria R3, with the Stage 2 camshafts. It works well as a daily driver, no problems with lumpy idling. With cam pulley tuning the car produced 136whp. Surprising to note that Siemens with the same setup produced more peak power (1-2whp), but less low-midrange torque thus fuelling the "bad pickup" comments on the Siemens EMS.

 

[k3et]

so sifu advice to put 262/264/272 degree?

 

[flushafteruse]

actually cams are not juz compare the degrees,u must see also the lift,,,,thats more important coz higher lift can open valve more n longer

 

[fstr]

means 285 for carb engines also no problem laa?? :P