Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="Turbomaster1" data-source="post: 3638035" data-attributes="member: 43604">first issue.....cyllinder compression.....u mentioned ur compression for all cylinders are the same and ok....how much?.....if some oil leaks through the rings, it might seal off the damaged ring area and ur compression might go up.........so the best way is to inspect the rings and cylinder wall......anyway wat engine are u using?.....if it is a l200 or l500, u should use 10w-30, mitsubishi 10w 40....nissan 15w-50.....second....water level drop.....if u have to top up always that means there is a leak prob.......do a pressure test......see if there is anyleak....if no... check ur radiator cap....if water / coolant flow out too much at normal operating temp.....ur rad cap should be stuck open.......otherwise water wont just leak out from ur spare tank.......unless u overfill ........Bump: 1) oil level dropif compression is par to specs does not mean ur rings are ok....it might be ur oil control rings.... not the compression rings......oil that goes in the combustion chamber might seal off the worn ring area....thats why u r achieving good compression......about the type of oil.....i dunno wat engine u using.....so generally.....daihatsu 10w-30, mitsubishi 10w-40, nissan/ toyota 15w-50......if there alot of air or gas coming out from the breather nozzle, that means there is blow by from ur cylinders.....this can cause oil level drop2)water level drop..you mentioned water leaks out from spare tank....might be overfill but it might be ur radiator cap stuck open.......check for anysigns of leak as welll....anywhere... do a pressure test....</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body
Nissan Almera Tomei body kit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Interested for the Car and Looking for Advice Subaru Impreza WRX STi V8

Dear awesome folks,

It has been a while since I visited zth and it is of great pleasure returning here with a thirst for cars after many years moving back from Melbourne.

I have to admit that I do not know much...

Unichip tuner

may like to install unichip to my car , i think the only 1 can perform dyno tuning around KL area is the RS IMPRESSIVE at Puchong , anybody try dyno there b4 ? good tuner ?:hmmmm:

sabah/sarawak AP vs local AP

what the different sabah/sarawak Ap compare to local Ap...? as i know sabah sarawak AP more cheaper n get loan from bank less than local Ap!!!