Menu
Home
Post Something
Forums
Current Activity
New posts
Search forums
What's new
New posts
Latest activity
News & Features
The Marketplace
Cars for Sale
Engine and Performance
Chassis and Wheels
Exterior and Body
Interior and Cockpit
ICE - In Car Entertainment
Car Shops and Services
Toys and Wares
All Other Stuff
Jobs and Vacancies
Looking For
Members
Log in
Register
What's new
Search
Search
Search titles only
By:
Current Activity
New posts
Search forums
Menu
Log in
Register
Reply to thread
See what others are reading now! Try Forums >
Current Activity
Home
Forums
Main Forums
Car Talk
Small jerking
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="k0pi" data-source="post: 1064501037" data-attributes="member: 117648"><p>Cleaning TB - this is pretty much a myth actually because the only problem with mikuni tb is when the gasket leaks air / ISC air leak valve jammed (whch opens & closes when you turned on aircond, triggered by AC compressor ON/OFF signal to the ISC). What you should actually clean is the mass airflow sensor transistor (located inside of the MAF which you can see hanging from the inside ceiling behind a pole) and you can clean it with a few dash of TB cleaner and carefully wipe it dry with tissue. Don't turn the MAF upside down while spraying the TB cleaner as it might flood onto the MAF circuit board and causes major problem.</p><p></p><p>Arospeed's & HotBits plug cables not bad & not very expensive, ard RM160-190... but honestly... the OEM plug cable is very good, very low resistance actually and delivers as much volt to the cable end as produced at the distributor cap even at high rpm - despite its quite boring, skinny... black... to look at... think the OE cable is ard RM140/set at Proton Parts Center.</p><p></p><p>IF, you want to change the plugs... try NGK BKR6E-11. That's the OE plug for 92p.</p></blockquote><p></p>
[QUOTE="k0pi, post: 1064501037, member: 117648"] Cleaning TB - this is pretty much a myth actually because the only problem with mikuni tb is when the gasket leaks air / ISC air leak valve jammed (whch opens & closes when you turned on aircond, triggered by AC compressor ON/OFF signal to the ISC). What you should actually clean is the mass airflow sensor transistor (located inside of the MAF which you can see hanging from the inside ceiling behind a pole) and you can clean it with a few dash of TB cleaner and carefully wipe it dry with tissue. Don't turn the MAF upside down while spraying the TB cleaner as it might flood onto the MAF circuit board and causes major problem. Arospeed's & HotBits plug cables not bad & not very expensive, ard RM160-190... but honestly... the OEM plug cable is very good, very low resistance actually and delivers as much volt to the cable end as produced at the distributor cap even at high rpm - despite its quite boring, skinny... black... to look at... think the OE cable is ard RM140/set at Proton Parts Center. IF, you want to change the plugs... try NGK BKR6E-11. That's the OE plug for 92p. [/QUOTE]
Insert quotes…
Verification
Post reply
The Marketplace Latest
original rare Rays Volk Racing TE37 SAGA S-Plus...
Started by
david tao
Chassis and Wheels
original Swift Springs rear strut bar set made in...
Started by
david tao
Chassis and Wheels
Proton Preve R3 body kit
Started by
jeff6126
Exterior and Body
Perodua Ativa gear up body kit
Started by
jeff6126
Exterior and Body
BMW F10 Mperformance front skirt lip
Started by
jeff6126
Exterior and Body
Honda Civic FC fk7si front bumper set
Started by
jeff6126
Exterior and Body
brake caliper spray
Started by
jeff6126
Exterior and Body
BMW F30 M3 bodykit/diffuser set
Started by
jeff6126
Exterior and Body
Perodua Axia Rahmah bodykit
Started by
jeff6126
Exterior and Body
Nissan Almera Tomei body kit
Started by
jeff6126
Exterior and Body
Posts refresh every 5 minutes
ceramic coating
Any body knows any good place to do this on
1) piston
2) or any other engine internals
pro's n con's?
any thoughts out there? care to share?
HELP. Crashed my R34 GTT
I recently had an accident and damaged frontal and driver side rear of my car. Currently trying to help my repair shop source for parts. Does anyone here has contact or spare dealer or parts provider that stock...
Volvo Alcoguard To Help Reduce Drink And Drive
Volvo announces their latest innovative technology. A device called the "Alcoguard" to help reduce road accidents caused by drink...
Recent Posts
Toyota Malaysia Enters Regional GT Racing with TGR Racing Malaysia
Started by
The_Mechanic
News and Features
Home Win and Double Podium for Akash Nandy at Sepang Season Opener
Started by
The_Mechanic
News and Features
Darker Design : Mercedes-Benz Launches GLA Nightfall Edition in Malaysia
Started by
The_Mechanic
News and Features
Honda Malaysia Doubles Down on Hybrids: New CR-V Launches with Dual e:HEV...
Started by
The_Mechanic
News and Features
BateriHub Reaches 200-Store Milestone, Becomes Malaysia’s Largest...
Started by
The_Mechanic
News and Features
Search
Online now
Enjoying Zerotohundred?
Log-in
for an ad-less experience
Home
Forums
Main Forums
Car Talk
Small jerking