Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="shiroitenshi" data-source="post: 1678242" data-attributes="member: 27518">I assume you're reading the tps reading off somewhere? VAFC?As with all sensors reading the TPS, it needs to be calibrated, since the voltage for off-throttle and full throttle is different.. it's not very accurate, but it's usually not very far off.. maybe in the region of 1%.I'd say check the wires.. and I assume you know the correct reading for the resistance of the TPS sensor at shut throttle plate when you mount the thing on the throttle body already?If it's already correct, it might be that irregular voltage going into the TPS sensor due to various other problems (wiring/short-circuit/etc/etc)Use the VAFC sensor check feature to find out (assuming you did wire the thing correctly)Could be other problems though. I'm just pointing out what it seems like to me from your description.</blockquote>

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

Someone broke my Z antenna.

Well just realized it when I arrive at home :bawling:

. So now I need to replace it. How much for the new antenna? Or any better aftermarket? Thanks.

DIY Install soundproof

Hi,

just finished install soundproof to my ride.

tools needed : Pen-knife, ruler(metal), clean cloth, 10mm,12mm spanar..etc, screw driver

Soundproof material : Sikadamp-630 1box 18" x 32" + sikadamp -630 (800mm x...

How to change the Wira antenna?

Hi, I need a help over here. My Wira antenna is spoil and I wish to replace it with a new one. I bought the antenna already, but when I want to pull the antenna out from the pillar (above the driver seat), I...