Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="lan evo" data-source="post: 443721" data-attributes="member: 735">1. I do not have answers for this.2. Low pass means that frequencies below the cutoff point will be passed through. This is usefull for woofer. High pass means any frequency above the cutoff will be passed through. This normally applies for tweeters.3. The idea is to set your gain to a level that will not cause your amp and speakers into distortion. Set it at a minimum before raising it up slowly until you can hear distortion. But, this is not that easy especially for woofers. 4. This I assume is to use the amp built in crossover. If you have an electronic crossover, there might be no need for you to use the amp's internal crossover. If you don't have one, this can be used as mentioned in answer 2. However, please be carefull as you don't want to send high frequencies to your woofer and low frequency to your tweeter.Just read the manual (if it comes with one) to better understand the operation of your amplifier.Hope this helps.[snapback]848016[/snapback][/b]</blockquote>thanks for your reply.one more noob question.what is distortion?bunyi pecah?thankslooks for more answer[/QUOTE]

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

ZTH-MAC First Ever TT!

Anyone up for it? No confirmed location, date and time yet. I am open for suggestions. :)

hks evc3 setup..

hks evc3 boost controller setting.

as topic above.i need help to all mloc member that who know how to setup the hks evc3. means how to set higher boost and others.

at first i only know to set lower boost and...

wts: ganador for CT9A

item sold....