Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="meg_omen" data-source="post: 1075722" data-attributes="member: 6316">JianHangbros,i went to JH myself following the direction from the posted map in ZTH. my decision to chose JH are based on comments from ZTH forummers. cost RM750 complete with installation plus another RM25 for changing the exhaust mounting(hardware shop). price are for 2nd hand FGK Jasma s-flow and 2 centre bullet, 1 is specially made by JH for auto tranny. also the cat removed.sifo EFN tested my car after helping me installing my RSM actually. his commented that my overall setup fro AE111 with 4AFE is okay and responsive for stock engine with auto transmission.what i meant in my previous post is that better you search/go to JH. i found their workmanship is far better than WeiYip.rgds.--> the piping is 1.78" and muffler inlet 2" outlet 3".p/s: as one of ZTH sifo mentioned....there's a lot of infos in ZTH and also in the net. it's best to do research before you start doing anything.</blockquote>

Verification

The Marketplace Latest

original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body
Nissan Almera Tomei body kit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

wt-ask: fender bar for CT9A

anyone know if there is any fender bar for CT9A ?

this one from J-Speed, anyone know where to find in malaysia ?
they call it "side tower bar".

http://i241.photobucket.com/albums/ff55/boonewe/jbrace.jpg...

Any remarks on td05 18g

I was told recently that there are some problems with the td05 20g highbrid, so now only available td05 18g, any comments/using. Looking at doing this upgrade.
BTW what should my min size injector be for this upgarde?

What happen to the few last msg post??

all msgs these few days all gone... anyone know wat happen?

server prob again??