Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="normality78" data-source="post: 2033886" data-attributes="member: 17">Recently i've read up some articles, found out a good IC SHOULD not only lower down the temp but also to improve flow which shld be the factor if we ever wanna change it.However the articles also did some dyno test with a few various IC, Ebay IC, thier own local country made IC and branded one. I was suprise to know that in majority of the IC does lowered the intake temp however the flow rate drop which result lower hp rating. The articles did mentioned lowering the air temp is important as its to prevent detonation which result enable higher boost but also at the same time the flow should not be neglect out which majority does.SO what are the key element in choosing the IC? Bar, Plate, Fin? With more and more local intercooler manufacture is popping out, what do you guys think of those IC quality?Having used Evo7 IC selling around RM900 onwards, its very contracting with some aftermarket performance IC for an example Apexi Hybrid IC which can be get around RM700 onwards as well. But which would you preffered?</blockquote>

Verification

The Marketplace Latest

original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body
Nissan Almera Tomei body kit
- Started by jeff6126
- Exterior and Body
original rare Black Racing Pro N1 16x6.5jj offset...
- Started by david tao
- Chassis and Wheels

Posts refresh every 5 minutes

Volvo Malaysia's latest Showroom promises new Retail Experience

Volvo Car Malaysia and Federal Auto Holdings Berhad have officiated its new showroom in Menara MBMR to replace their...

Any good place to change my hyundai Accent 2006 exhaust system?

Dear all GURUs,

Need yours precious advice on where I should go to change my car exhaust system?

The car I'm driving is Hyundai Accent 1.5GL.

Hope to hear from you guys.

Thanks in advance.

Cheers!!

Electronic Turbo

Ok here is an idea. Electronic turbo...mild boost. Get a turbine and modify it to fit a 12v high speed brushless motor (seen some at 70000rpm at 50kW)....Drive the compressing blades into trottle body. Turn on only...