Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="nan83" data-source="post: 3808974" data-attributes="member: 6718">yaa.. e6x can be operate in close loop.. stock narrowband o2 sensor can be use, just connect to haltech... if use plug & play hardness, no need to do wiring, just enable o2 close loop at halwinX software .. but need to configure it lah, such as target mV & etc.. if use hicam, cannot close loop at idle, so set min rpm tu 2000rpm.. coz tuning idle for hicam need a bit rich ..for the antilag system... it can be configure to be launch control or antilag... just do some configuration in halwinx it will effect differently..antilag setup:-connect a switch to AUX.IN (pin 28), this switch to activate antilag system-at halwinx, go to SETUP-->Input/Output Setup-->Aux in funtion = set to ANTILAG-Input-connect a solenoid valve to PWM.OUT4 (pin 24) . normally out4 free. if it have been use, change 1 or 2 or 3... but dun disable radiator fan control lah.. hehe ( solenoid valve is use to supply air to engine while throttle is close )-at halwinx, go to Options-->PWN & dig out option--> tick at PWM4 enable --> select Antilag Switch , than click properties.. enable zero tps only than configure retard ign value, % increase fuel & etc...-enjoy antilag system..For launch control-same as above just need to configure like below--at halwinx, go to Options-->PWN & dig out option--> tick at PWM4 enable --> select Antilag Switch , than click properties.. disable zero tps only than configure retard ign value, % increase fuel , On RPM ( put 5000rpm if wanna launch at that rpm) & etcanother function is flat shift (change gear while full throttle)-connect a clutch switch to AUX.IN (pin 28), this switch need to install at clutch paddle.. so when you press clutch, flat shift system will activate-at halwinx, go to SETUP-->Input/Output Setup-->Aux in funtion = set to flat shift-this no need to configure.. enjoy flat shift</blockquote>

Verification

The Marketplace Latest

original rare spec Rays Volk Racing RE30 15x7jj...
- Started by david tao
- Chassis and Wheels
original rare Rays Volk Racing TE37 SAGA S-Plus...
- Started by david tao
- Chassis and Wheels
original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body

Posts refresh every 5 minutes

CVC Looks to Offload F1 Shares Valued at US$10 Billion

CVC Capital Partners Ltd...

need some info about 350Z

i had owner it for a month -z33 ......

i curious about some prob about z33

my car spec is below:
auto
19' rim 245 front 275 rear
adjustable abs (tein super street)
fujitsubo ext ( from cat to back)

when i cruise...

Altezza meter cluster

May I know when (which year) did they change the tacho to the centre dial for the 5AT version?

thanks.