Reply to thread

See what others are reading now! Try Forums > Current Activity

Message: <blockquote data-quote="speedking" data-source="post: 512909" data-attributes="member: 318">thanks for the reply bro, but bro i think is the other way round...when my clutch is low, it is abnormally low(super low)...but when it is high is become abnormally high(super high)...but after my mech release the air, only it become normal...the engage point is around half release of the clutch pedal...like wat u mentioned the clutch is low if the shaft is stuck is quite logic, but how come it become super high after engine warm up? coz when my mech install the new clutch pump and when everything is working fine, the engage point is only half release of clutch pedal...weird er.... cause if the rust has been scrape off it should become normal like half pedal to engage clutch right? and I just change my clutch pad, clutch cover and the bearing 3 months ago... and this thing happen only after i change the above item...now it is getting worst</blockquote>

Verification

The Marketplace Latest

original Swift Springs rear strut bar set made in...
- Started by david tao
- Chassis and Wheels
Proton Preve R3 body kit
- Started by jeff6126
- Exterior and Body
Perodua Ativa gear up body kit
- Started by jeff6126
- Exterior and Body
BMW F10 Mperformance front skirt lip
- Started by jeff6126
- Exterior and Body
Honda Civic FC fk7si front bumper set
- Started by jeff6126
- Exterior and Body
brake caliper spray
- Started by jeff6126
- Exterior and Body
BMW F30 M3 bodykit/diffuser set
- Started by jeff6126
- Exterior and Body
Perodua Axia Rahmah bodykit
- Started by jeff6126
- Exterior and Body
Nissan Almera Tomei body kit
- Started by jeff6126
- Exterior and Body
original rare Black Racing Pro N1 16x6.5jj offset...
- Started by david tao
- Chassis and Wheels

Posts refresh every 5 minutes

to tune a/f ratio and ignition on hyundai getz

as the subject above, any sifu here know and can share any method to tune the a/f and ignition of a hyundai getz 1.3?? need this since plan to low boost it.... heard ppl use safc for a/f but ignition how?

sifu pls...

Ringing sound from clutch

As most of you would've known, by using a metal clutch (single, twins, triple etc) it would give a ringing sound when the clutch pedal is depressed. Once the clutch engages and in gear, the noise would no longer be...

DEFI replacement sensors

Hey guys,

Anyone know if we can use other sensors to fit into DEFI control unit II? I heard we can use auto gauge sensors, which I do not know how true it is. Any ideas?

By the way, anyone knows the detail spec of...